JOINT IT All WEATHER JOINTING MORTAR 20kg tub's
The fastest and easiest way to point you drive or patio
 
? Patios.
? Footpaths.
? Pedestrian walkways.
? Car space areas up to 3 tonnes loading. 
 
Description: Joint-It is a ready-to-use self-curing jointing material for all types of paving with joints of 3mm
wide and a minimum depth of 25mm Joint It is a fast and easy way of jointing your paving
and doesn't require any special tools. Joint-It is suitable for sandstone, concrete paving,
slate, clay paving terracotta and granite.
Surface Preparation:
Make sure that all paving and joints are clean and free from oil, dirt, etc and that paving isn't
loose.
 
COVERAGE
Approx. Quantities Required
Joint Size 30mm deep x 5mm wide Joint Size 30mm deep x 8mm
wide
600 x 600mm 14.0 m² 600 x 600 9.0 m²
600 x 450mm 11.0 m² 600 x 450 7.0 m²
450 x 450mm 10.0 m² 450 x 450 6.0 m²
600 X 300mm 9.0 m² 600 X 300 5.0 m²
These are only approx. guidelines for a 12.5kg bucket of joint it
Storage: Store in a cool, dry place.
Packaging: 12.5kg-20kg and in vacuum pack bag in sealed bucket.
Working temperature: 0°C - 40°C
 
Application:
? Joint-It comes ready to use and no further mixing is required.                                                            Setting Time:
? Setting time is based on temperatures of 20°C, cold/wet weather increases the
setting times and warm/dry weather decreases them.
? Joint It is a mortar that water and oxygen cures.
? In summary, in temperatures of 20°C the joints need to be free from water for about 6
hours for the curing to complete.
? Pedestrian areas are safe to walk on after 8-16 hours and will go hard after 24 hours.
It can be fully load bearing after 3-5 days of warm and dry weather. More time should
be allowed for driveways up to 3 tonnes loading
Benefits:
? Supplied ready for use.
? 12 month shelf life.
? Can be used in all weather.
? Just brush into joints, spray with water and brush off.
? Water permeable.
? Made for joints of 3mm and wider.
? Weatherproof.
? Resists weed growth.
? Non-staining.
? Sets hard.
? Joint It is environmentally friendly and contains natural ingredients including silica
sand.
? Joint-It is not to be used below 0°C.
? Joint-It can be used in rainy conditions.
? Pre-wet all paving firstly
? Pour Joint-It over all paving area and squeegee across all paving
? Using a spray hose, wash Joint-It into all joints.
? Top up any sagging joints with Joint It and lightly spray with water again.
? Repeat steps if needed.
? To finish, use a light spray of water or a soft brush to clean off the paving.
? Allow water to drain away and the paving to dry out.
? Joint-It will withstand the rain during application and afterwards but heavy rain will
slow down curing time and it may be necessary to top up joints later.
? Any Joint-It left on slabs can be swept off, diagonally to the joint, that day. 
Uses for Joint It:
? Patios.
? Footpaths.
? Pedestrian walkways.
? Car space areas up to 3 tonnes loading.
Limitations:
? Joint depths must be a minimum of 25mm and not less than 3mm wide.
? In vehicle accessible areas it is essential that the paving elements are laid on the
required bed concrete base and the concrete squeezed up the joints. This is to
provide stability for the paving elements in order to withstand twisting forces of
wheels but 25mm depth of Joint It is essential in joints of the paving
? Joint-It is to be considered for aesthetics and not for its structural properties. There
should be no reliance on Joint It to form any structural elements for paving.
? Joint-It should be free from any high pressure washers for at least 28 days keeping
nozzle of washer 30cm away from joints.
? Make sure to follow the manufacturer’s instructions.
? Joint It Ltd cannot be fully aware of all of the applications and materials the product
may be used on. It is the consumer’s responsibility to determine suitability for use.
? In warm weather as indicated, pedestrian areas are safe to walk on after 8-16 hours
and will go hard after 24 hours. It can be fully load bearing after 3-5 days of warm
and dry weather. More time should be allowed for driveways up to 3 tonnes loading.
? However on busy driveways allow 7 days for traffic.
? Joint-It will achieve its fullest strength after approximately 4 weeks.
Precautions:
? For health and safety precautions, refer to the safety sheet which can be downloaded
at www.jointit.com


This product is temporarily unavailble.