You have no items in your shopping cart.
Each bag of Joint-It Fine will cover approximately 10m² of brick/block paving where the joints are less than 3mm wide.
Always test a small hidden portion of the surface before use to ensure appearance and performance is acceptable. Suitable for lightly loaded surfaces (up to 3.5 tonnes).
Joint-It Fine should be applied in dry weather conditions at temperatures above 2°C.
Joint-It Fine should only be used with block/brick paving laid on a water-permeable base with joints under 3mm wide.
Sweep sand into clean and dry joints.
Compact sand into joints using a vibrator / whacker plate.
Use a leaf blower to remove excess sand from the top of the surface.
Wet paving with a light, fine spray and wait 5-10 minutes. Then thoroughly soak the paving.
Ensure that surface is clean and dry before opening the bag.
You will need a compactor/wacker plate and a leaf blower to complete the application of
Joint-It® Fine.
Store product, including open bags, in a dry place. Product does not cure/harden on contact with air. Product will be adversely affected by storage in damp conditions.